Friday, September 2, 2011

Riving knife proto 2

So I made a few changes to the prototype in the shop. Not to much but I did lower the parallel arm 3/4". about as low as I can get it. The further apart the arms are the more they stay in parallel. To mount the arm to the trunnion I decided to go with 2 1/4" blocks. I can mount one to the saw to give left right adjustment. and the other mounted at 90 will have up/down/front/back alignment. So I can tune in the position of the pivot. I also increased the size of the ring 1/4. and shortened the overall length of the arm.


The plan is to try and make a new prototype this weekend. But first I am going to mock up the knife and it's mount.

4 comments:

  1. Tim

    How could I possibly get the drawings from you to create one for myself? I am currently rebuilding my unisaw and it is an absolutely 'must' to have a riving knife fitted to a table saw. You can currently see my rebuild on OWWM. http://www.owwm.org/viewtopic.php?f=1&t=175856

    Regards

    ReplyDelete
  2. Hi Tim:

    You appear to have done such a great job on this. It seems that after 2011 your blog has gone cold. Like the fellow who commented above, I too would love to get my hands on this, assuming it would work for my old Delta Unisaw 34-814.

    Best wishes

    ReplyDelete
  3. Can you email me plans please. danbozza@yahoo.com

    ReplyDelete